– 33 –
FS 913 M / FS 913 P
EN
CleanIng and Care
Before performing any cleaning and care:
Read the general safety information about
cleaning in the chapter “safety information“.
Turn the oven off.
– Depending on how the oven is installed:
Unplug the oven or disconnect the power at
the main electrical system switch, e.g., switch
off the fuse of the oven in the fuse box.
General recommendations
Stains on the base of the oven from various cooking
products (sauces, sugar, proteins and fat) are always
caused by spills and splashes. Splashes occur during
cooking and are usually the result of cooking at too
high temperatures. Spills occur when using cooking
dishes which are too small, or due to an incorrect
estimate of increases in volume during cooking.
These problems can be avoided by using deep
cooking receptacles or by using the enamel trays
supplied with the oven.
The stainless steel and enamelled parts of the oven
will remain as good as new if cleaned regularly with
water or special detergents.
Ensure that the oven is cold before you start
cleaning.
Do not use steam cleaners or direct jets of water.
Do not use coarse abrasive materials or sharp
metal scrapers to clean the glass parts of the
oven door. They could scratch the surface and
cause the glass to shatter.
Never use scouring pads, steel wool, muriatic acid
or other products which could scratch or mark
the surface.
Only use hot water and non-abrasive detergents
when cleaning the enamelled surfaces and the
oven chamber.
Use a branded glass cleaner for the glass.
Using the auto clean function
This function is only available on ovens with pyrolitic
cleaning function, like FS913P.
The AUTO CLEAN function turns oven cleaning
into a quick, easy and instant procedure. The
temperature reached in the cooking compartment
(450°C) carbonizes all food and fat residue. During
this process, some particles of residue may glow;
this is a normal phenomenon due to instantaneous
combustion.
If the AUTO CLEAN function is activated, the oven
door is locked after the first two minutes cycles and
cannot be opened. The padlock icon lights up.
The obscuring of the LCD display during the
pyrolitic cleaning process is a precautionary display
protection feature caused by the high temperatures
in use.
Before cleaning
Accessories left in the oven may hinder the
correct circulation of heat on all the walls or may
be damaged due to the high temperatures.
Remove all accessories (enamel trays, racks,
runners, telescopic guides).
Do not leave anything inside the oven.
Remove food residues using a moist sponge.
Never use detergents or any other specific
cleaning product.
Do not obstruct the circulation of air in the area in
front of the oven.
Do not leave anything on the door handle.
The surfaces may become very hot during
pyrolytic cleaning process.
Keep children away.
Clean the internal glass panel with a mixture of
water and soap.
Start the AUTO CLEAN function at the display.
After cleaning
Clean the internal glass panel with a glass cleaner.
Dry all parts of the oven thoroughly after cleaning.
To Next Page
Loading...
Need help?
General