– 36 –
FS 913 M / FS 913 P
EN
Lift the telescopic
guide (3) while
pulling out (2)
towards the other
side of the oven.
Remove the
telescopic guides.
2
3
Remove the side frames
Bend the crosspiece which is engaged in the
fixing bush downwards and remove it from the
groove.
Push the side frame upwards and remove it from
the two upper hooks.
Cleaning
Clean the side frames and the telescopic guides.
After cleaning, keep the side frame tilted and
insert the side frames into the two respective
guides on the top.
Bend the crosspiece which is engaged in the
fixing bush upwards and insert it in the groove.
Insert the telescopic guides.
Replacing the oven lamp
Franke ovens are equipped with two rectangular
lamps. The replacement lamp must meet the
following technical specifications:
– Temperature resistance: 300°C
– Voltage: 220-240 V, 50/60 Hz
– Power: 40 W
– Connection: G9
CAUTION! Damage to the lamp due to wrong
handling!
Avoid touching the lamps with bare hands.
Use a cloth or a sheet of kitchen paper.
WARNING! Possibility of electric shock!
Ensure that the oven is switched off before
replacing the lamp.
WARNING! Electric shock due to wrong
handling!
Switch the oven off.
– Depending on how the oven is installed:
Unplug the oven or disconnect the power at
the main electrical system switch, e.g., switch
off the fuse of the oven in the fuse box.
Remove the glass cover by carefully prying it off
with a flat-blade screwdriver.
Remove the lamp from its holder.
Replace the lamp.
Reattach the glass cover.
To Next Page
Loading...
Need help?
General