Alliance/Racor Models: turn the drain plug
clockwise to close it.
DAVCO Models: close the drain valve.
Install and hand-tighten the vent cap.
6.
Inspect the steering components.
6.1
Inspect tie rods, steering arms, and the
drag link for signs of looseness (i.e., shiny
spots or rust tracks). See
Fig. 21.17 for a
rack and pinion steering gear; see
Fig. 21.18 for an integral steering gear.
6.2
Check the steering gear mounting bolts
and pitman arm nut, if equipped, for signs
of looseness.
6.3
Check the drag link nuts for missing cotter
pins.
6.4
Inspect the steering intermediate shaft and
end yokes for excessive looseness or
other damage.
NOTICE
Do not drive with a drive belt that is visibly worn
or damaged. If it fails, the lack of coolant flow
could rapidly cause damage to engine compo-
nents.
7.
Inspect the serpentine drive belts for signs of
glazing, frayed edges, breaks, cracks, or oil con-
tamination.
1
2
3
4
5
02/17/2012 f090497
1. Air Cleaner
2. Vacuator Valve
3. Rain Tray Seal
4. Rain Tray
5. Drain Hose
Fig. 21.12, Rain Tray Assembly
03/08/2012 f090498
1
1
1. Vacuator Valves
Fig. 21.13, Hood Interior
Pre- and Post-Trip Inspections and Maintenance
21.12
To Next Page
Loading...
