6
13
Component code
The component code identifies the faulty components within a major system. In case the
faulty component does not appear in the component code of the specific section, there is a code
for ‘Other parts’ in every section.
The ‘Environment’ section is an exception, as it does not relate to any system in the
Robomower. It describes conditions outside the Robomower that can cause
difficulties/problems/failures during operation such as high grass, slopes, etc. When the
‘Environment’ section is selected the defect code will be defined as ‘Irrelevant’ (ZZ).
Defect code
The defect code describes the type of problem discovered with the component identified in
the section and component codes above. This problem is something that you can:
- See visually (broken, damaged, torn, missing etc.)
- Understand from your analysis (Dead/weak, Over heat etc.)
- Know about from your experience (S/W bug)
6.1.2.3 Repair Code
The repair code identifies the actual repair that was made to rectify the failure defined in the
failure code.
Repair Code
D
Repair Code
A Explanation
B Cleaning
C Calibration / Refit / Adjustment
D S/W upgrade
E H/W upgrade
F Repair
G Replacement (Main board)
H Replacement (part)
I Replacement (Robot)
J Failure not found
K Robot returned
Z Other
The repair code defines the action taken by the person that had solved the problem. The repair
codes are organized from the easy to the more difficult actions.
To Next Page
Loading...
