To Next PageTo Next PageWhat to do if nothing is shown on the display of my Froling Boiler?
If nothing is shown on the display of your Froling Boiler, first ensure that the main switch is turned on. Also, check whether the FI circuit breaker or line protection is switched on. Finally, inspect the fuse in the controller and replace it if faulty, noting the amperage (6.3AT). The issue might be a general power failure.
Why is nothing shown on the display of my Froling Boiler?
If the display is blank, there could be a few reasons: * There might be no power to the controls due to a tripped FI circuit breaker or line protection. In this case, switch on the FI circuit breaker or line protection. * There could be a general power failure; switch on the FI circuit breaker or line protection. * A fuse in the controls might be faulty; replace the fuse, noting the current (10AT). * The main switch might be turned off; turn on the main switch.
What to do if my Froling S3 Turbo displays _999 °C_?
If the display shows _999 °C_, it indicates that the sensor is incorrectly connected or there's a shortcut in the sensor cable. Check the connection and the sensor cable.
What to do if my Froling S3 Turbo Boiler displays _127 °C_?
If the display shows _127 °C_, this means that the sensor is not connected or interrupted. Connect the sensor or check the sensor cable.
What does _SZG - display_ mean on my Froling S3 Turbo Boiler and what should I do?
If the display shows _SZG - display_, it indicates that there is no confirmation (approx. 2min) from the induced draught speed sensor. You should check the plug connection and connection cables of the induced draught fan, check the position of the speed sensor, and ensure the induced draught fan is working.
General