Fronius TransTig 2200 - MMA Rod Electrode Setup; Opening the MMA Rod Electrode Setup

Rod elec. setup (rod electrode setup)
Open the rod
electrode setup
1
Press the Mode button to select the MMA welding mode
The image for the rod electrode welding parameter is shown on the display,
e.g.:
2
Press Menu key
The main menu appears:
3
Use the adjusting dial to select "Rod elec. setup" (turn the adjusting dial)
4
Press the adjusting dial
The rod electrode setup parameters are shown:
The power source is now in the rod electrode setup.
133
EN