Fronius TransTig 2200 - Advanced TIG Setup; Opening the TIG Setup 2 nd Menu; Modifying Advanced TIG Parameters

TIG setup 2nd
Opening the TIG
setup 2nd
1
Opening the TIG setup
2
Select the 'TIG setup 2nd' parameter
3
Press the adjusting dial
The TIG setup 2nd parameters are shown:
The power source is now in TIG setup 2nd
Changing weld-
ing parameters
1
Select the desired welding parameter by turning the adjusting dial:
2
To set the welding parameter, press the adjusting dial
The value of the selected welding parameter can now be changed:
98