Fronius TransTig 2200 User Manual

2
Actuate the torch trigger
Shielding gas flows.
3
Gradually tilt the welding torch up until
the tungsten electrode touches the
workpiece
4
Raise the welding torch and move it
into its normal position
The arc ignites.
5
Carry out welding
End of welding
1
Depending on the set mode, finish welding by releasing the torch trigger
2
Wait for the set gas post-flow and hold welding torch in position over the end of the
weld seam
58

Fronius TransTig 2200 Specifications

General

Brand	Fronius
Model	TransTig 2200
Category	Welding System
Language	English