Fronius TransTig 2200 - TIG Setup Configuration; Opening the TIG Setup Menu

TIG setup
Opening the TIG
setup
1
Press the Mode button to select 2-step mode or 4-step mode
The image for the TIG welding parameter is shown on the display:
TIG welding parameters for 2-step mode
TIG welding parameters for 4-step mode
2
Press Menu key
The main menu appears:
3
Use the adjusting dial to select "TIG setup" (turn the adjusting dial)
4
Press the adjusting dial
The TIG setup parameters are shown:
The power source is now in the TIG setup.
92