Fronius TransTig 2200 - Advanced MMA Rod Electrode Setup; Opening the Advanced MMA Setup; Modifying Advanced MMA Parameters

Rod elec. setup 2nd (rod electrode setup 2nd)
Opening the rod
electrode setup
2nd
1
Open the rod electrode setup
2
Select the 'rod electrode setup 2nd' parameter
3
Press the adjusting dial
The parameters for rod electrode setup 2nd are shown:
The power source is now in rod electrode setup 2nd
Changing weld-
ing parameters
1
Select the desired welding parameter by turning the adjusting dial:
2
To set the welding parameter, press the adjusting dial
The value of the selected welding parameter can now be changed:
137
EN