Polarity
Unit -
Setting range AC (only MagicWave) / DC- / DC+
AC frequency
only with MagicWave for the TIG AC welding process
Unit Hz
Setting range Syn / 40 - 250
Syn for mains synchronisation of two power sources for simultan-
eous AC welding.
IMPORTANT! If using the "Syn" setting, remember to check the "Phase sync." para-
meter in AC setup 2nd.
Low frequency soft, wide arc with shallow heat input
High frequency focused arc with deep heat input
Balance
only on MagicWave for TIG AC welding process
Unit -
Setting range -5 - +5
-5: wide arc with shallow heat input
+5: highest cleaning action, lowest fusing power
162
To Next Page
Loading...
Need help?
General
