Tools
190
Tools
5
POP3 Server Settings
Set the POP3 server. In [POP3 Server Settings], you can set the following items:
z
For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to 255.
z
For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
z
When you make an entry mistake, press the <C> (Clear) button and enter again.
îš„ Server Name/IP Address
Enter a server name or IP address with up to 128 characters, and then select [Save].
îš„ Port Number
Enter a port number from 1 to 65535.
The default value is 110.
z
Do not use the numbers assigned to the other ports.
îš„ Polling Interval
Set the interval for checking the e-mail on the POP3 server from 1 to 120 minutes in 1
minute increments.
îš„ Login Name
Enter the name to login to the POP3 server with up to 64 characters.
îš„ Password
Enter a password for the POP3 server with up to 64 characters.
Enter the same password in [New Password] and [Retype Password] using the numeric
keypad displayed by selecting [Keyboard]. If you do not set the password, leave the text
boxes blank and select [Save].
îš„ POP Password Encryption
Select [On (APOP)] to encrypt the password.
SMTP Server Settings
Set the SMTP server. In [SMTP Server Settings], you can set the following items:
You can check the connection between the machine and the SMTP server by sending a test
mail to the e-mail address specified in [Connection Test]. Selecting [Connection Test] >
[Print SMTP Comm. Report] outputs the report that shows the contents of protocol of the
SMTP communication transmitted and received by the machine.
z
For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to 255.
z
For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
z
When you make an entry mistake, press the <C> (Clear) button and enter again.
îš„ SMTP Server Name/IP Address
Enter a server name or IP address, and then select[Save]. Up to 128 characters are allowed.
To Next Page
Loading...
Need help?
General
