Maintenance
74
Maintenance
3
z
Images output from the machine may get dirty after the message "Please order Drum Cartridge" appears on
the touch screen.
Replacing Staple Cartridge (for Finisher-A1)
When the optional Finisher-A1 is installed and the staple cartridge needs to be replaced, a
message appears on the touch screen. When this message appears, load a new staple case
into the staple cartridge.
z
The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance. Use only
staple cartridges recommended by Fuji Xerox.
z
When the machine is in the Power Saver mode, exit the Power Saver mode by pressing the <Power Saver>
button and the <Machine Status> button on the control panel before you replace the staple cartridge.
z
When replacing the staple cartridge, press the <Machine Status> button and check the current status for the
staple cartridge even when the control panel is lit.
z
To order a staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not operating, and open the finisher front door.
2
Take the staple cartridge out of the finisher.
3
After you take out the staple cartridge, check inside of the finisher for any remaining
staples.
To Next Page
Loading...
Need help?
General
