Fuji Xerox C7776 Administrator's Guide

Error Code
595
Problem Solving
15
Other Errors
This section describes the remedies when the following messages are displayed.
133-701
[Cause] Unavailable characters are included in Name, Company Logo,
Fax Comment, or Local Name and the characters are converted.
[Remedy] Enter available characters to Name, Company Logo, Fax
Comment, or Local Name.
When the available characters are not clear, enter alphanumeric
characters only.
133-710
[Cause] When printing the received fax document, the paper loaded on
the bypass tray was used for printing because the specified tray
could not be used.
[Remedy] Take one of the following measures:
z
Load paper available for printing the received fax document:
A3SEF , A4LEF , B4SEF , B5LEF , A4SEF , A5SEF
, B5SEF , 8.5 X11”SEF , 8.5 X 13”SEF , 8.5 X 14”SEF ,
11 X 17”SEF , 8.5X 11”LEF , 5.5 X 8.5”SEF .
z
Use a paper type available for printing the received fax
document:
plain paper, bond paper, recycled paper, side 2 paper, user-
defined custom paper.
z
Confirm the settings by selecting [Tools] > [Fax Service
Settings] > [Fax Control] > [Receiving Paper Size].
1) Select [Receiving Paper Size] > [Tray Mode] to add a tray to be
used for printing the received fax documents.
2) Set up paper so that the tray specified for [Tray Mode] can be
used for printing the received fax documents.
If the error still is not resolved, contact our Customer Support
Center.
ErrorMessage Cause and Remedy
A fault has occurred.
Switch off the machine.
(xxx-yyy)
[Cause] An error occurred.
[Remedy] Switch off the machine power, make sure that the
touch screen is blank, and then switch the machine
power on again.
If the message persists, record the content displayed
for [(xxx-yyy)]. Then immediately switch the main
power and power off, make sure that the touch
screen is blank, and then contact our Customer
Support Center.
Completed with an error.
(xxx-yyy)
[Cause] An error occurred, and the operation terminated
abnormally.
[Remedy] Execute the operation again.
A fault has occurred. The
machine has rebooted.
Select [Close]. If the
problem persists, call for
service.
(xxx-yyy)
[Cause] An auto-recoverable internal error occurred, and the
machine restarted automatically.
[Remedy] Select [Close] to use the machine normally. If the
error still is not resolved, contact our Customer
Support Center.
Error Code
Cause and Remedy

Fuji Xerox C7776 Specifications

General

Brand	Fuji Xerox
Model	C7776
Category	All in One Printer
Language	English