Fax Service Settings
229
Tools
5
2 Pages Up On Receipt
Set whether or not to print two pages of a fax document on one side of a sheet. This is
convenient for saving paper.
For example, when two A5 pages are received, they are printed on a single A4 sheet.
However, if paper of the same paper size as the received document is specified in [Receiving
Paper Size], it is printed on the specified size of paper. Depending on the sizes of the
received document, two pages of the document may not be printed on one sheet of paper.
2 Sided Printing
Set whether or not to print received fax documents (including the Internet fax received
documents) as 2 sided. This is convenient for saving paper.
z
Even if you select [On], depending on the data, 2 sided printing may not always be possible.
Edge Erase - Top & Bottom Edges
Specify the amount of edges erased from the document in the top and bottom directions.
Specify a value from 0 to 20 mm in 1 mm increments.
Edge Erase - Left & Right Edges
Specify the amount of edges erased from the document in the left and right directions.
Specify a value from 0 to 20 mm in 1 mm increments.
Reduce 8.5 x 11" Original to A4
When [Reduce/Enlarge] in the [Layout Adjustment] screen is set to [Auto %], you can set
whether or not to reduce 8.5 x 11” size document to A4 , while scanning the document.
Pseudo-Photo Gradation Mode
You can select a gradation expression mode. Selecting this mode enables the machine to
change the processing method for gray part (halftone) to achieve near-photo quality.
Select either [Error Diffusion] or [Dither].
Changing this setting also changes the photo gradation mode for Color Scanning (Black &
White).
Folder Selector by G3 ID
Set whether or not to use the Folder Selector by G3 ID feature.
The Folder Selector by G3 ID feature allows you to classify received documents according
to sender's G3ID and store them to specified.
z
When the machine does not send sender's G3 ID to a recipient, the recipient may not send recipient's G3 ID.
In this case, the received documents cannot be classified according to G3 ID.
z
Due to that G3 ID is manually registered by a sender, the telephone number set for G3 ID may be wrong. You
can find G3 ID sent by the sender in a Job History Report.
z
You can find the G3 ID of the sender in "Input Source" column of a Job History Report.
To Next Page
Loading...
Need help?
General
