ESC/P-K Emulation
643
Appendix
16
Reduce/Enlarge 17
(Variable %/
vertical
magnification
)
Sets the magnification for the vertical or horizontal direction.
[45 to 210](Default:100): 45-210%
z
When a continuous form paper is selected for [Original Size], print result is
identical for [Preset %] and [Fit to Cut Sheet].
18
(Variable %/
horizontal
magnification
)
2 Up mode 21 2Sets whether to print with the 2 Up or page by page. 2 Up is a feature that
prints two pages onto one sheet of paper. Depending on the paper
orientation, the two pages are printed side by side, or one above the other.
[0](Default): Off
[1]: Forward
[2]: Reverse
z
When [Landscape] is selected for [Original Size], print result is identical for
[Forward] and [Reverse].
Output destinatio 9 Sets the output tray for the printouts.
[0](Default):Center Tray or Center Tray - Lower
[1]: Left Top Tray (optional)
[2]: Center Tray - Upper
[80]: Right Middle Tray (optional)
Tray 5
confirmation
67 Prints from Tray 5, after you instruct to print and then operate the machine
to start printing.
[0](Default): Off
[1]: On
Grid lines 22 Sets the method for printing double-byte grid lines. The options are as
follows.
[0](Default): Image
[1]: Font
2 Sided printing 12 Sets the 2 sided printing.
[0](Default): Off
[1]: Head to Head
[2]: Head to Toe
z
When [Postcard] is selected for [Paper Size], [Head to Head] and [Head to Toe]
cannot be selected.
Font 13
(Chinese
character
fonts)
Sets the font for double-byte characters.
[3](Default): ShuSong
[4]: FangSong (optional)
[5]: HeiTi (optional)
[6]: KaiTi (optional)
14
(Alphanumeric
fonts)
Sets the font for single-byte characters.
[0](Default): Roman
[1]: Sanserif
z
Since this feature selects the default value, its setting will not be affected when an
extended command is received.
Setting Item Item Number Value
To Next Page
Loading...
Need help?
General
