ESC/P-K Emulation
645
Appendix
16
ESCP switch 60
(Paper feed
position)
Sets the position to start printing at 8.5 mm or 22 mm below the top edge of
paper.
[0](Default): 8.5mm
[1]: 22mm
61
(CR feature)
Sets the action to be executed when a CR command is received.
[0](Default): Carriage return
[1]: Carriage return and linefeed
Positionadjustme
nt
15
(Vertical
position
adjustment)
Adjusts the printing position vertically or horizontally, and changes the
positions of the margins.
[0](Default): Off
[1-500]: -250 to +250 mm
16
(Horizontal
position
adjustment)
z
Data outside the printable area is not printed regardless of the adjustment of the
print position. In addition, data moved outside the printable area as a result of
adjusting the print position is not printed.
Escape sequence 62
(Escape
sequence)
A normal extended command is specified starting with hexadecimal 1BH ESC
as the escape sequence identifying the command, followed by ; (3BH). When
you cannot use a semicolon or ESC code with the host computer, you can use
a special string instead as an escape sequence. This setting specifies whether
or not to enable the escape sequence replacement feature. When enabling,
specify the escape sequence with item 63.
[0](Default): Disabled
[1]: Enabled
z
For more information on extended commands, contact our Customer Support
Center.
63
(Escape
sequence
character)
To control an extended command with a text code, you must specify an
escape sequence (the first two bytes) of the extended command.Enter two
characters using the keyboard displayed on the screen.
[&%](Default) : 0x21 - 0x7e
Form overlay 64 Constantly performs Form Overlay by selecting a form name (No. 01-64)
registered on the machine.
[0](Default) : Off
[1-64]: No. 1 - No. 64
z
Since the default value is selected for this feature, this setting is not affected when
an extended commend is received.
z
Once a form name is selected, it continues to be displayed even if the form is
deleted. When a form name is selected using the up and down arrow keys, it is not
displayed. In this case, the setting is set to "Off".
Stapling 66 Sets the stapling position.
[0](Default) :Off
[1]: Top left
[2]: Top Double
[3]: Top Right
[4]: Left Double
[5]: Right Double
[6]: Bottom Left
[7]: Bottom Double
[8]: Bottom Right
Bypass Tray -Wait
User
67 Sets whether to suspend the print processing when feeding paper from the
Bypass Tray. Processing is resumed by a user operation on the machine.
[0]: Off
[1](Default): On
Setting Item Item Number Value
To Next Page
Loading...
Need help?
General
