z
When Trays 1 to 4 is selected, the paper size is determined by the size of paper
loaded in the tray, and thus [Paper size] cannot be set.
Paper tray 103
z
When [Auto] is selected and paper of the same size in the same orientation in
multiple trays is loaded, paper will be fed in the order of Tray 1 J Tray 2 J Tray 3
J Tray 4. If paper of the same size is loaded in multiple trays but in different
orientations, feeding of the paper loaded in the landscape orientation is prioritized.
Auto layout 106 Selects whether to perform auto layout of the document or not.
[0](Default):ON
[1]: OFF
Active palette 107 Selects whether to use a pen specified by command or set on the panel.
[0](Default):Command
[1]: Panel
No. of prints 108 Sets the number of copy to be printed.
[1] - [250] (Default: 1) : 1 - 250
Output
destination
109 [0] (Default) : Center Tray - Lower
[1] : Side Tray (optional)
[2] : Center Tray - Upper (optional)
[80] : Right Middle Tray (optional)
[81] : Right Top Tray (optional)
z
When the optional Extra Center Tray is installed, "Center Tray - Lower" is used as
the Center Tray.
[0] (Default) : Right Top Tray
[80] : Right Middle Tray (optional)
[0] (Default) : Center Tray or Center Tray - Lower
[2] : Center Tray - Upper
[80] : Right Middle Tray (optional)
[0] (Default) : Right Top Tray
[80] : Finisher Tray (optional)
[0] (Default) : Center Tray
[80] : Finisher Tray (optional)
[0] (Default) : Center Tray or Center Tray - Upper
[1] : Left Top Tray (optional)
[2] : Center Tray - Lower
[80] : Finisher Tray (optional)
[68] : Stacker Tray (optional)
[69] : Stacker - Top Tray (optional)
[80] : Finisher Tray (optional)
[81] : Right Top Tray (optional)
2 sided printing 110 Sets 2 sided printing.
[0] (Default) : None
[1] : Head to head
[2] : Head to toe
To Next Page
Loading...
Need help?
General
