EasyManuals Logo

Fuji Xerox C7776 Administrator's Guide

Fuji Xerox C7776
751 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #688 background imageLoading...
Page #688 background image
Appendix
688
Appendix
16
keypad either. Consequently, the recipients you can specify are limited to those who are
registered on the Address Book.
You must add an address book entry using CentreWare Internet Services or Device Setup
Tool (free software). The system administrator, however, can register new recipients from
the control panel of the machine even when the method of recipient specification is
limited.
z
The users who belong to an authorization group for which [Restrict Recipient Selection
Method] is set to [No Restriction] can directly specify a recipient for fax/Internet fax or
an e-mail transmission.
îš„ One-Touch Buttons
The One-Touch buttons (only for fax models) are used to specify an address when sending
faxes, IP faxes, internet faxes, Scan to PC, or E-mail. The buttons cannot be used when you
specify an e-mail address, a shared folder of SMB/FTP, or a server address.
The following two methods are available to assign the address numbers to the One-Touch
buttons.
z
[Type 1]: Assigns the One-Touch buttons 1 to 52 to the address numbers 0001 to 0052,
and buttons 53 and 54 to the stored programming jobs 1 and 2.
z
[Type 2]: Assigns the One-Touch buttons 1 to 45 to the address numbers 0001 to 0045,
and buttons 46 to 54 to the stored programming jobs 1 to 9.
Note
z
[Type 1] is selected by factory default.
Reference
z
For more information on how to change the number of address numbers assigned, refer to "One-touch Buttons" (P.133).
îš„ Assigning to the One-Touch Buttons
You can change the way how address numbers and stored programs are assigned to the
One-Touch buttons. When you have changed the assignment, some One-Touch buttons
that were used for address numbers before may be used for stored programs while other
One-Touch buttons that were used for stored programs before may be used for address
numbers. Be sure that you perform the correct operation.
îš„ IC Card Reader (optional)
z
There are two types of IC Card Reader you can choose: the Embedded IC Card Reader
(optional) and the IC Card Reader for Wing Table (optional).
z
Installing the IC Card Reader to the machine enhances the authentication function of
the machine. Also, you can restrict the usage of the machine and improve the security
management feature and availability of documents.
z
The following EP accessories can be simultaneously installed on the machine with the IC
Card Reader.
- Foot Switch
- Dispenser 2
- IC Card Cashier
-Coinkit 8
-Coinkit 9
Note
z
When you want to install IC Card Cashier, contact our Customer Support Center. Our service representative
performs the installation and configures the settings.

Table of Contents

Other manuals for Fuji Xerox C7776

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox C7776 and is the answer not in the manual?

Fuji Xerox C7776 Specifications

General IconGeneral
BrandFuji Xerox
ModelC7776
CategoryAll in One Printer
LanguageEnglish

Related product manuals