Output Format
129
Copy
3
Handout Tray
Allows you to select the paper tray to be used for the handouts.
Select [More] to display the [Paper Supply - Handout] screen on which you can select
a tray.
Note • When you use the bypass tray, select [Bypass] on the [Paper Supply - Handout] screen.
When [Bypass] is selected, the [Tray 5] screen is displayed. For more information, refer to "[Tray 5]
Screen" (P.74).
Copy Output (Specifying Finishing Options)
This feature allows you to select finishing options.
Note • Optional finishing module is required to enable this feature. For more information, contact
your local Fuji Xerox representative.
If the Offset Catch Tray is installed, the output position of copies is offset alternately to
separate each set of copies.
If the finisher is installed, each set of copies can be stapled, and then output. The output
destination is automatically selected depending on the selected feature. Outputs are
delivered to the output tray when [Auto] is selected, while outputs are delivered to the
finisher tray when [Collated] or [Uncollated] is selected. For the machine with the
Finisher C2 with Booklet Maker or the Finisher D4 with Booklet Maker, when [Fold &
Staple] for [Booklet Creation] or [Single Fold] for [Folding] is selected, outputs are
delivered to the booklet tray.
1 Select [Copy Output].
2 Select any option.
Auto
Copies are collated when any of the following features is used: 2 Sided Book Copying,
Covers, [Blank Separators & Handouts] or [Transparency Set & Handouts] of
Transparency Options, Booklet Creation, Stapling, Build Job, Sample Set, and
Combine Original Sets.
To Next Page
Loading...
Need help?
General
