Layout Adjustment
97
Copy
3
Auto Detect
Detects the document size automatically. The following table shows the document
sizes that can be detected automatically.
Note • If the document size cannot be detected automatically, a screen to enter the document size
appears.
The document sizes that can be automatically detected depend on [Paper Size Settings] in the System
Administration mode. For more information, refer to "5 Tools" > "Common Service Settings" > "Other
Settings" > "Paper Size Settings" in the Administrator Guide.
Standard Size
Select a document size from preset options.
You can change the sizes displayed on the screen. For information on the settings, refer to "5 Tools" >
"Copy Service Settings" > "Original Size Defaults" in the Administrator Guide.
Variable Size
Enter the desired scan size when scanning a non-standard size document or when
making copies at a size different from the original document size. You can specify a
value in the range from 15 to 432 mm for the width (X), and a value in the range from
15 to 297 mm for the length (Y), in 1 mm increments. To help you specify values, use
the scales attached on the upper and left edges of the document glass.
Important • When the document is loaded in the document feeder, the base point in the Y (length)
direction is the center of the edge. If you specify 100 mm, the scan length will be from 50 mm
above to 50 mm below the center of the document.
Mixed Size Originals (Scanning Different Size Documents
Simultaneously)
You can scan documents of various sizes simultaneously and make copies on each
size or a single size of paper. To use this feature, load the documents in the document
feeder.
Important • Load documents in landscape orientation. However, always load A5 documents in portrait
orientation.
• When loading B5 documents together with A3 documents loaded in landscape orientation or
A4 documents loaded in portrait orientation, load B5 documents in portrait orientation.
• If the top left corners of the documents are not aligned properly, the documents may not be
scanned correctly.
• The recommended document size combinations are A4 portrait and A3 landscape, or B5
portrait and B4 landscape. If another combination of document sizes is used, the documents
can be fed at an angle and may not be copied properly.
Note • This feature does not appear for some models. An optional component is required. For more
information, contact your local Fuji Xerox representative.
Document Feeder Document Glass
Auto-detectable
Document Sizes
B5, B5 , B4, A5, A5 , A4,
A4 , A3, 8.5 x 11",
8.5 x 11"
, 11 x 17", 16K ,
8K
B6, B6 , B5, B5 , B4, A6,
A5, A5 , A4, A4 , A3
To Next Page
Loading...
Need help?
General
