Layout Adjustment
169
Scan
4
Proportional %
Allows you to select a preset ratio, or enter a value in the range from 25 to 400% in 1%
increments.
Use the numeric keypad or [+] and [-] to enter a value.
z
Variable %
Enter the scanning ratio. Specifying "100%" scans at the same image size as the
original document.
z
Preset %
Select from preset ratios.
You can change the default values of scan ratios other than [100%]. For information on the settings,
refer to "5 Tools" > "Scan Service Settings" > "Reduce/Enlarge Presets" in the Administrator Guide.
Enter Output Size
In [Output Size], select the output size of the
scanned document. The machine
automatically calculates the scanning ratio
based on the selected output size and the
original document size.
Note • Selecting [Enter Output Size] may
generate blank margin areas.
Original Orientation (Specifying the Orientation of the Loaded
Documents)
This feature allows you specify the orientation of the loaded document.
When you load the top edge of the document against the left side of the document glass
or the document feeder, and then select [Sideways Images], the document is displayed
in the correct orientation when viewed on your computer screen.
Note • If the [Original Orientation] setting differs from the actual document orientation, the machine
may not detect the top of the document correctly.
z
Upright Images
Select this option when placing the top edge of the document against the top side of
the document glass or document feeder.
z
Sideways Images
Select this option when placing the top edge of the document against the left side of
the document glass or document feeder. Always select [Sideways Images] when the
top of the document is placed facing the left side (horizontal text).
To Next Page
Loading...
Need help?
General
