Calling a Stored Program
181
Stored Programming
5
Calling a Stored Program for Build Job
You can call a stored program for Build Job on the [Copy] screen displayed while Build
Job is running.
1 Select [Change Settings].
2 Select the [Job Assembly] tab.
3 Select [Stored Programming].
4 Select a number of a stored program containing the features you want to use.
Note • You can only select registered numbers.
• After the stored program has been called, the machine sounds an audible tone. If a failure
occurs, the machine sounds a fault tone.
For information on how to change the volume of the sound that notifies that a stored program has been
called, refer to "5 Tools" > "Common Service Settings" > "Audio Tones" > "Stored Programming
Complete Tone" in the Administrator Guide.
To Next Page
Loading...
Need help?
General
