2 Product Overview
42
Product Overview
2
Switching the Power On
The following describes how to switch the power on.
The machine takes approximately 90 seconds to warm up and to be ready to copy or
print after switching the power on. This may take more time depending on your machine
configuration.
Switch the power off at the end of the day or when not using the machine for an
extended period of time.
Also use the Energy Saver feature to save power consumption while the machine is not
in use.
For information on the Energy Saver feature, refer to "Energy Saver Mode" (P.45).
1 Press the power switch to the [ | ] position to
switch the power on.
Note • The “Please wait...” message indicates
that the machine is warming up. The
machine is not available during warming
up.
• If the machine is not powered on, check
the following:
•The power cord is plugged in.
•The main power is switched on.
•The <RESET> button is in the depressed
position.
Switching the Power Off
The following describes how to switch the power off.
1 Before switching the power off, make sure that the machine has completed all copy
jobs. Then, make sure that the <Data> indicator is not lit.
Important • Do not switch the power off in the following situations. If the power is switched off, the
processing data may be erased.
• While data is being received
• While a job is being printed
• While a job is being copied
• While a job is being scanned
• When switching the power off, wait 5 seconds after outputs have been delivered.
To Next Page
Loading...
Need help?
General
