Getting s tarted
Getting started
Gettingstarted
Please observe the safety information in the "Important notes", Page 9 ch apter.
Unpacking and checking the delivery
It is recommended no t to throw away the original pa ckaging material! It may be
required for reshipment at some later date.
PackagingContentsofdeliv eryPackaging,
► Unpack all the individual p arts.
► Check the contents of the package for any visible damage caused during transport.
► C heck whether the delivery conforms to the details in the delivery note.
► Should you discover that the delivery does not correspond to the delivery
note, notify your loca l sales outlet immediately.
Steps for initial setup
Preparingf or firstuse, overviewPreparingf or use,
Only a few steps are n ecessary to put your new device into operation for the first time:
• Select a location for device and set up device
• Connecting external devices
• Check the voltage at the mains outlet and co nnect the device t o an electrical outlet
• Switch the device on
You will learn more about the individual steps in the following sections.
External devices
If you have received other external devices in addition to your own de vice (e.g.
a printer), do not connect these until after the initial installation. The f ollowing
sections describe how to connect these external devices.
Drives and boards
If you have received drives or boards with your device, please do not install
them until after first-time setup. How to install drives and bo ards is described
in the "
System expansions", Page 31 chapter.
12 Fujitsu Technology Solutions
To Next Page
Loading...
