Fujitsu CELSIUS R920 - Installing;Removing a 3½ Reader in a 3½ Bay (Optional, Smartcard or Multicard)

System expansions
2
1
► Place the drive cover on the casing (1).
► Slide the drive c over downwards (2) s o that th e drive cover clicks into the ca tches.
► If necessary, make the required settings o n the remaining hard disk d rives.
► If you are not installing a new drive , reinstall the cover (optional) w hich was
previously removed. The drive bay must be closed off to ensure cooling, to protect
against fire and to prevent the entry of foreign bodies.
► C lose the casing (see "
Closing the casing", Page 34).
It may be necessary to modify the entry for the drive in the BIOS Setup .
Installing/removing a 3½" reader in a 3½" bay
(optional, SmartCard or M ultiCard)
You can for instance install a SmartCard or MultiCard reader in the 3 ½" drive bay. The
reader is mounted onto a module h o lder when installed in the casing.
SmartCard or MultiCard readers can be mounted on a mo dule holder (optional).
If you have ordered a device with a SmartCard or MultiCard reader, the module
holder, SmartCard or MultiCard reader are already built in on delivery.
If you have orde red a device without a SmartCard or MultiCard reader, a
blind cover is installed instead o f the module holder.
38 Fujitsu Technology Solutions