System expansions
Securing the hard disk front panel
1
► Position the ha
rd disk front panel in the guide openings on the bottom of the casing as illustrated.
► Fold the hard disk front panel in the direction of arrow (1) until you feel it engage.
Remove and install type 1 boards
You can insta
ll ad ditional m odules in order to increase the performance of your machine.
The number,
position and arrangement of the b oard slots on the mainboard can be found in
the manual
for the mainboard. Boards may already be installed on shipment.
Type 1 boar
ds are installed at the lower rear area inside the casing.
If you ha
ve already insta lled a type 2 board, you must firstofallremoveit,
see "
Re
move and install type 2 boards", Page 69
Board
,
Board
,
Perform board installation
If you
wish to install a type 1 board, you must first remove the bo ard fan
and a
ny type 2 boards which are present from the cross-piece. Then fold the
cros
s-piece upwards so that you can install the board.
Thi
s p reliminary work is described in the following sections.
60 Fujitsu Technology Solutions
To Next Page
Loading...
