System expansions
Do not throw away the slot co ver. For cooling, protection against fire and in order to
comply with EMC regulations, you must refit the slot cover if yo u remove the board.
2
1
► Push the board into the slot (1).
► Sw ivel the retaining clamp back again until you feel it click into place (2).
► If necessary, connect the cables to the board.
► For display adapters with an additional power connection (< 65 W ): attach the
display ada pter pow er cable to the power supply.
If you have installed or removed a board, please check the relevant slot
settings in the BIOS Setup. If necessary, change the settings. Further
information is provided in the board documentation.
64 Fujitsu Technology Solutions
To Next Page
Loading...
