Fujitsu ETERNUS DX100 S3 - Page 165

10 Use the same method to create sessions for the remaining six generations.
Specify from "No.: 3, Name: sdv1" through to "No.: 8, Name: sdv6" for the copy destination volumes.
11 After all of the sessions are created, click the number of sessions in [SnapOPC+ Sessions].
12 Check the status of the copy source volume and the copy destination volume.
In this case, the copy source volume number is "0" and the copy destination volume numbers are from
"1" through to "7".
13 Open [Disk Management] from [Computer Management].
Chapter 9
Advanced Copy Settings
9.2 Performing a Copy (SnapOPC+)
165
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0