14 Change the status of all the disks with [Offline] to [Online]. In this case, change the status of Disk 1
through to Disk 8 to [Online].
After the status of the disks is changed to [Online], file systems and drive letters are assigned.
If any drive letter is unused, the unused drive letter is assigned in ascending order of the drive let-
ters, which results in discontinuous drive letters. Change the automatically assigned drive letter if
necessary.
15 Check if the file that was created in Step 8 in "■ Operation Disk Settings" (page 150) in "8.2.3.2 Disk
Settings" (page 150) is displayed for the copy source drive.
Chapter 9
Advanced Copy Settings
9.2 Performing a Copy (SnapOPC+)
166
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0
To Next Page
Loading...
