Fujitsu ETERNUS DX100 S3 - Page 34

4 Install the controller enclosure in the rack.
Do
• When installing or removing the controller enclosure to or from the rack,
make sure that the sides and the bottom of the controller enclosure are held
by two or more people. Failure to do so may cause injury.
5 Fasten the controller enclosure in the rack.
Use three M5 screws to fasten it in the rack pillar.
M5 screw
M5 screws
6 Attach the flange cover.
Chapter 2
Rack Installation
2.2 Controller Enclosure Installation (for Regions Other than EMEA&I)
34
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0