Fujitsu ETERNUS DX100 S3 - Page 39

2 Attach the rack rails to the rack.
(1) Insert the rack rails into the holes of the front and the rear rack pillars to lock the rail lock lever.
[Left]
[Right]
Rail lock lever
(Rack pillar: rear)(Rack pillar: front)
(2) Use the M4 screws to fasten the front and the rear rack rails.
Use the washers to fasten the rack rails to the front and rear rack pillars.
Make sure to attach the rack rails to rack pillars so that they fit exactly together without any
space between them.
(Rack pillar: front)
Washer
M4 screw
M4 screw
Washer
M4 screw
Washer
Washer
M4 screw
Rack rail
(left)
Rack rail
(right)
(Rack pillar: rear)
The M4 screw positions for the rack rails are determined by the high-density drive enclosure base
line.
Chapter 2
Rack Installation
2.4 High-density Drive Enclosure Installation (for Regions Other than EMEA&I)
39
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0