Insert the M4 screws in the second holes on the front and rear rack pillars above the base line to
fasten the rack rails.
High-density drive enclosure
Front/Rear
4U
Rack rail
High-density drive
enclosure base line
[Right][Left]
2nd hole
(M4 screw)
2nd hole
(M4 screw)
3 Install the stopper bracket (for left side) and the stopper bracket (for right side).
Attach the stopper bracket to the front rack pillar.
Stopper bracket
(left)
(Rack pillar: front)
Rack rail
(right)
Rack rail
(left)
M5 screw
M5 screw
(Rack pillar: rear)
Stopper bracket
(right)
The M5 screw positions for the stopper brackets are determined by the high-density drive enclosure
base line.
Insert the M5 screws in the seventh holes above the base line to fasten the stopper brackets.
4U
Rack rail
High-density drive
enclosure base line
7th hole
(M5 screw)
High-density drive enclosure
Front
[Right][Left]
7th hole
(M5 screw)
Chapter 2
Rack Installation
2.4 High-density Drive Enclosure Installation (for Regions Other than EMEA&I)
40
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0
To Next Page
Loading...
