• When two controllers are installed
Drive enclosure 2
Drive enclosure 1
Controller enclosure
(2) Attach the destination labels to the connectors of the cables between enclosures.
Controller number" or "Drive enclosure number - IOM number" is printed on the destination labels
in the "Connection origin DI port g Connection destination DI port" format. The "n" or "l" symbol
is also printed on the destination labels.
Carefully check the connection origin and connection destination, and then attach the destination
labels.
CM0 0
DE01 0
IOM (I/O module) number
Drive enclosure number
CM (controller) number
Chapter 4
Connecting Cables
4.2 Drive Enclosure Connection
59
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0
To Next Page
Loading...
