Fujitsu ETERNUS DX100 S3 - Page 60

The following figure shows an example of the destination label attachments on the cables be-
tween enclosures that connect the controller enclosure to drive enclosure 1 and that connect drive
enclosure 1 to drive enclosure 2.
Drive enclosure 2
Drive enclosure 1
Controller enclosure
2 Connect the controller enclosure to the drive enclosure and connect between the drive enclosures.
Connect Controller 0 first.
(1) Connect the controller enclosure to the drive enclosure.
Connect the DI (OUT) port of Controller 0 (CM#0) in the controller enclosure to the DI (IN) port of I/
O module 0 (IOM#0) in drive enclosure 1 with the cable between enclosures.
(i) Connect the plug to be connected to DI (OUT) port, to the DI (OUT) port of the Controller 0
(CM#0).
(ii) Connect the plug to be connected to DI (IN) port, to the DI (IN) port of the I/O module 0
(IOM#0).
Controller enclosure
Drive enclosure 1
(2) Connect between the drive enclosures.
Connect the DI (OUT) port of I/O module 0 (IOM#0) in drive enclosure 1 to the DI (IN) port of I/O
module 0 (IOM#0) in drive enclosure 2 with the cable between enclosures.
Chapter 4
Connecting Cables
4.2 Drive Enclosure Connection
60
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0