The procedure for initial setup is shown below. For details on the settings, refer to "Configuration Guide (Web
GUI)".
1 Click the [Next >>] button in the [Initial Setup] screen.
The [Set Storage System Name] screen appears.
2 Set the name of the ETERNUS DX Disk storage system.
Set the name of the ETERNUS DX Disk storage system.
The information that is set here is used for network management by SNMP. The name of the ETER-
NUS DX Disk storage system is displayed in the login and operation screens of ETERNUS Web GUI.
Chapter 5
General Settings
5.4 Storage Management (Initial Setup 1)
78
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0
To Next Page
Loading...
