(1) A message to confirm whether to register the SED authentication key is displayed. Click the [Next
>>] button.
A confirmation screen appears.
(2) Click the [OK] button.
The SED authentication key is registered and the registration completion screen appears.
(3) Click the [Done] button.
The [Setup Network Environment] screen appears.
• The SED authentication key can be registered even if no SEDs are or will be installed.
• When SEDs are already installed in the ETERNUS DX Disk storage system, a message that re-
quests rebooting appears. Reboot the ETERNUS DX Disk storage system according to the dis-
played message.
7 Set the network environment.
Set the ETERNUS DX Disk storage system environment for network communication.
Chapter 5
General Settings
5.4 Storage Management (Initial Setup 1)
82
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0
To Next Page
Loading...
