Manufacturer’s no tes
For Authorized Repair Technicians O nly
CAUTION:
For continued protection against r isk of fire, replace only with the
same type and rating f use.
WARNING:
Danger of explosion if Lithiu
m (CMOS) b attery is incorrectly replaced. Replace only
with the same or equivalent ty
pe recommended by the m a nufacturer.
Dispose of used batteries a cc
ording to the manufacturer’s instructions.
FCC Regulatory i nformation for notebooks with radio device
Regulatoryinf ormation
Federal Communications Commission statement
This device complies with Part 15 of FCC Rules. Op eration is subject to the following
two cond itions: (1) this d evice may no t cause interfe rence, and
(2) this device must accept any interference, including interference that may
cause undesired operation of this device.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. T hese l imits are designed to provide reason able
protection against harmful interferen ce in a residential installation. This equipment generates,
uses, a nd can radiate radio frequen cy energy. If not installed and used in accordance with
the instructions, it may cau se harmful interference to ra dio communications.
However, there is no guarantee that interference will not o ccur in a particular installation.
If this equipment does cause harm ful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measu res:
1. Reorient or relocate the receiving antenna.
2. Increase the distance betw een the equipment an d the receiver.
3. Connect the equipment to an outlet on a circuit different from the one the receiver is connected to.
4. Consult the dealer or an experienced radio/TV technician for help.
Please note the following r egulatory information related to the optional radio d evice.
FCC Radio Frequency Exposure statement
This radio device has been evaluated unde r FCC Bulletin OET 65C and found compliant w ith the
requirements as set forth in CFR 47 Sections 2.1091, 2 .1093, and 15.247 (b) (4) addressing RF
Exposure from radio freq uency d evices. The radiated output power of this radio device is far below
the FCC radio frequency exposure limits. Nevertheless, this device shall be used in such a man ner
that the potential for human contact during normal operation is minimized. When using this device, a
certain s epa ration distance between antenna and nearby persons must be maintained to ensure RF
exposure compliance. In order to comply with RF e xposure limits established in the ANSI C95.1
standards, the distance between the antennas and the user should not be less than 20 cm (8 inches).
Regulatory Notes and Statements
Radio device, health and autho risation for use
94 Fujitsu Technology Solutions
To Next Page
Loading...
