Chapter 3 Information About Software 87
SPARC Enterprise
M3000/M4000/M5000/M
8000/M9000 Servers
XSCF User's Guide
2-177 You cannot set the memory mirror mode for a PSB in
M8000/M9000 servers.
The PSB#02 data is included erroneously for the procedures
example of M4000/M5000 servers in "Setting the Memory Mirror
Mode for a PSB" of Section 2.2.14 System Board Configuration.
The example will be changed as follows:
3. Use the showfru(8) command to confirm the setting of
memory mirror mode.
XSCF> showfru -a sb
Device Location XSB Mode Memory Mirror Mode
sb 00 Quad Yes
sb 01 Uni No
3-4 The description, "When you return to XSCF Shell console
without logging out from the domain, the return causes
automatically logging out from the domain. At this time, a
background program is forced to quit. To avoid the background
program force-quit, return to XSCF Shell console with logging
out from the domain. " in "Domain console (RW console)" of
TABLE 3-1 Types of Terminals Connected With XSCF will be
changed as follows:
If you return to the XSCF Shell from the domain console, or if
you terminate the XSCF Shell, both without logging out of the
domain, you will be automatically logged out from the domain.
At the same time, a termination signal might be sent to any
program that is running in the background on the domain
console.
TABLE 3-12 Software Documentation Updates (Continued)
Title Page Number Update
To Next Page
Loading...
