Chapter 3 Information About Software 29
RTIF1-
070904-002
O O When the snapshot CLI attempts to
write to a USB stick that has write
protect set results in an I/O error.
Do not attempt to use write-protected
USB devices for collecting snapshot.
RTIF1-
070904-003
O O An incorrect domain state is reported.
After the command sendbreak(8) to
domain is issued,
showdomainstatus(8) continues to
show the state as "Running" when the
domain is actually at "ok" prompt.
No workaround is available. This is
expected behavior of the
sendbreak(8) operation.
RTIF1-
070904-005
O O Time can't be synchronized with the
NTP server.
Check the stratum value of the NTP
server.
The stratum value of XSCF is "5." The
NTP server which the XSCF refers to
must be a server on which the stratum
value is smaller than 5. When you
changed the NTP server to refer to,
reboot the XSCF.
When the stratum value has been set
correctly and the time can't be
synchronized, use the showntp(8)
command to check the jitter value to
be displayed.
If this value is large, please reboot the
XSCF.
RTIF1-
070904-006
O O While executing the domain power-
on, domain reset or DR, in case the
XSCF reset occurred, the process may
be aborted in some or all of the XSB.
Execute the domain reset one more
time, or power off the domain and
then power on again.
RTIF1-
070912-001
O O If an invalid SMTP server is
configured, a subsequent attempt to
disable e-mail service (using the
setemailreport CLI) may block for
up to 30 minutes.
Wait for the CLI to complete. The rest
of the system will function normally
during this time.
• The CLI can also be aborted by ^C.
Note that the operation (disabling
e-mail report) is completed, even if
^C is used.
• showemailreport can be used to
confirm that the e-mail service has
been disabled.
TABLE 3-3 XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
ID M3000
M4000
M5000
M8000
M9000 Description Workaround
To Next Page
Loading...
