Chapter 3 Information About Software 31
RTIF1-
070914-010
O O On the XSCF Web, on the [SNMPv3
Security Settings] screen, when you
select [Add User] or [Copy User] of
the [SNMP User-Based Security
Model (USM)], the [Create or Copy
User] screen appears as a pop-up. On
this screen, when you set the SNMP
User with 16 digits or more, it will be
registered correctly but the web
browser screen displays up to 15
digits.
When you set the SNMP User with 16
digits or more, use the
showsnmpusm(8) command.
RTIF1-
070914-011
O O On the XSCF Web, on the [SNMPv3
Security Settings] screen, when you
select [Change Password] of the
[SNMP User-Based Security Model
(USM)], the [Change Password] screen
appears as a pop-up. On this screen,
despite the [Confirm Password] is a
field which must be entered, it is not
displayed with the note "*
Indicates require field."
Do not fail to set Confirm Password
which is a field must be entered.
RTIF1-
070914-012
O O On the XSCF Web, on the [SNMP-
Properties] screen, when you don't
select [Trap Host] and execute the
[Remove] button, the invalid message
"The trap host will be
removed" appears as a pop-up. And
when you select [OK] on the pop-up
screen, the invalid message "Remove
trap host failed. setsnmp:
invalid trap type" appears.
None available at this time.
RTIF1-
070914-013
O O On the XSCF Web, on the [Audit-
Properties] screen, when you execute
the [Add Policy] button, the [Set User
Policy] appears as a pop-up. On this
screen, when you specified a user
name which is not registered in XSCF
and an input error resulted, the value
entered won't be cleared though you
execute the [Reset] button to clear the
specified user name.
Set the correct user name or execute
the [Cancel] button to close the pop-
up screen.
TABLE 3-3 XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
ID M3000
M4000
M5000
M8000
M9000 Description Workaround
To Next Page
Loading...
