Chapter 3 Information About Software 45
RTIF1-
090430-001
OOOAfter you set https (using the self
certificate authority) by XSCF and
created a web server certificate, https
is not enabled.
To set the self certificate authority, do
not specify a blank character.
RTIF1-
090508-001
OOOIn a domain mounted with the 10
Gigabit Ethernet card (SE0X7HE1F),
when you set the OpenBoot PROM
environmental variable diag-
switch? to true, the following
warning message appears on the
console; and at the same time, "Msg:
Device error (FCode informed
error)" is recorded in the error log.
WARNING: /pci@7,700000: FCODE
map-in doesn't match decoded
register type;
And when you execute the
showstatus(8) command,
"Degraded" might be indicated to the
FRU which has installed the relevant
card.
The entire output can be safely
ignored.
To avoid these outputs, execute the
following command at the ok prompt
and set the OpenBoot PROM
environmental variable diag-
switch? to false.
setenv diag-switch? false
RTIF1-
090729-001
OOOWhen you use the sethttps(8)
command to create a self-signed web
server certificate, if the number of
characters specified in a parameter
exceeds 100, it might result in an
internal error and you might fail to
create the certificate.
Specify up to 100 characters in the
parameter and execute the
sethttps(8) command again.
RTIF1-
090824-001
OOOThe XSCF might go down and require
a reboot, or you might see console
error messages and a core dump
(ereport.chassis.software.cor
e) when one of these conditions
occurs:
• A local account has been created
with a user ID explicitly assigned to
a value larger than 65536 (adduser
-u uid).
• An LDAP account has been used
that has a UID value larger than
65536.
Use only user accounts with a user ID
(UID) value between 100 and 60000.
This is the range of auto-assigned
UIDs for the XSCF command
adduser(8).
TABLE 3-3 XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
ID M3000
M4000
M5000
M8000
M9000 Description Workaround
To Next Page
Loading...
