First-time setup of your device
First-time setup of your devic
e
First- time setu pGettingstarted
Read the c hapter "Important notes", Page 11.
The necessary hardw are drivers and the supplied software for the
device are already pre-installed.
Beforeyouswitchonthedeviceforthefirst time, connect it to the mains voltage
using the mains adapter, s ee "
Mains adapter connecting", Pag e 16.Themains
adapter must be connected d uring the entire installation process.
A system test is performed when your device is first switched on. Various messages
can appear. The display may rem ain dark for a short time or may flicker.
Follow the instructions on the screen.
NEVER switch off your device during the first-time setup p rocess.
The battery is permanently installed in the system and must be charged if you
want to use your device under b attery operation.
When used on the move, the built-in ba ttery provides the device with the necessary power. You
can increase the operating time by using the available energy-saving functions.
Refer to chapter "
Connecting exte rnal devices", Pa ge 59 for instructions on how to connect
external devices (e.g. mouse, flash stora ge) to your device.
Unpacking and
checking the device
Should you discover any damage that o ccurred during transportation,
notify your local sales outlet immediately!
► Unpack all the individual parts.
PackagingTranspo rt
► Check y our
device for any visible da m age wh ich may have occurred during transp ortation.
You may n e
ed the packaging in the future, if you need to transport your device.
Fujitsu Technology Solutions 15