Working wit h the Tablet PC
Replacing the stylus tip
With use, the stylus tip may become worn or may pick up foreign particles that can scratch the screen.
A damaged or worn tip may not move freely, causing unpredictable results when using the stylus.
If your stylus exhibits these problems, replace the stylus tip. To d o this, use the s upp lied t ool (1).
1
► To remove the tip, position it in the gap
between the two ends of the tool supplied.
► Pinch the two ends of the supplied tool
together so that the tip is firmly clasped,
then pull it from the barrel.
► Replace the tip with one of the new tips
that were supplied with your stylus. Insert
the flat end of the tip into the barrel
and exerting gentle pressure, push it
in until it is firmly in place.
If the tip is worn or damaged, discard it.
Calibrating the stylus
You must calibrate your Tablet PC with the stylus before first use, so that it
recognizes the stylus as accurat ely as possible.
You should also always repeat the calibration if the co-ordination between the
stylus and the c ursor movement deteriorates.
Operating system Menu
Windows 8.1 Desktop
To calibrat
e, ru n the Hardware and Sound / Tablet PC Settings function in th e
Control Pa
nel. You need to ca librate both portrait and landscape fo rmats.
32 Fujitsu
To Next Page
Loading...
Need help?
General