Appendix
Determining whether Recovery and Utility is pre-loaded
1. Turn on or reboot your system. When the Fujitsu logo appears, press the
F12
key.
2. Use the
Tab
key to get to the A pplication Menu.
3. Check whether the Recovery and Utility option is present. If it is not present, it means
that the utility must be used from the Bootable Disk. Proceed to “Running Recovery and
Utility from the Bootable Disk” if Recovery and Utility is unavailable.
Running Recovery and Utility from hard disk
1. Turn on or reboot your system. When the Fujitsu logo appears, press the
F12
key.
2. Use the
Tab
key to get to the A pplication Menu.
3. Cursor down to Recovery and Utility and press the
Enter
key.
4. Choose your language, if necessary. Select Reco very and Utility to proceed.
5. Three tool options appear: Diagnostics, Recovery,andUtility (refer to the Recovery and
Utility tools section below for instructions on how to use t hese tools).
6. If this w as successful please skip the ne xt step and go to “Recovery and Utility tools.”
7. If this was NOT successfu l, please g o to the next step .
Running Recovery and U tility from the Bootable disk
To verify/ change the boot-up priority (rather than booting-up from the hard drive or
an external media drive), perform the following steps:
1. Power on your system. When the F ujitsu logo appears on the screen, press the
F12
key.
2. Insert the bootab le disk into the drive tray.
3. Highlight the CD/DVD option f rom the Boot menu, then press
Enter
.
4. Click OK.
5. Select CD/DVD boot mode: UEFI Mode, if applicab le, and then press
Enter
.
While the files are being loaded from the disk, the Fu jitsu logo screen will appear
followed by a progress bar at the bot tom of the screen.
102 Fujitsu
To Next Page
Loading...
Need help?
General
Weight and Dimensions
