FULTON FHE-250 - Suspend Mode; CH Setpoint Adjust Mode

FHE-250 MANUAL 09 2014 ISSUE 2
Page 36
3
LCD:
seg1 to seg3 Displayed setpoint value, if not available “--” is displayed, blinking when
adjusted
dgr + seg5 Symbol °C or °F if temperature value is valid
ch Always blinks
P2 Blinks when parameter is modied and can be saved.
Button Press: Function:
D (autorepeat) Decrement setpoint value
E (autorepeat) Increment setpoint value
Briey B Write setpoint value if modied and exit
Note: After 10 seconds of keyboard inactivity, mode exits without updating the setpoint value.
3.14.5
CH SETPOINT ADJUST MODE
3.14.4
SUSPEND MODE
LCD:
stb Always on
P2 Always blinking
Button Press: Function:
D for 3 secs. Start of Auto Detection procedure
Briey B Exit from Suspend mode to Standby mode
Note: In the Suspend mode, both BH and DHW service is inhibited with exception of frost protection.
A
B
C
E
D
G
F
A + C for 3 sec.
D briey.
A
B
C
E
D
G
F