FULTON FHE-250 - Installer+ Mode

FHE-250 MANUAL 09 2014 ISSUE 2
Page 41
3
LCD -when selecting the parameter index:
seg1 Displayed “P”
seg2 to seg3 Index number (starting from 1)
i1 + i2 + spn Installer+ mode indication
LCD -when showing value:
seg1 to seg3 Displayed value, if not available a string “--” is displayed, blinking when
adjusted
P2 Blinks when parameter is modied and can be saved
i1 + i2 + spn Installer+ mode indication
Button Press: Function:
B+C for 3 sec. Exit Installer+ mode
Briey B Write value if changed, switch between index and value screens
D (autorepeat) Decrement index number, skip to index selection screen
E (autorepeat) Increment index number, skip to index selection screen
F (autorepeat) Decrement parameter value
G (autorepeat) Increment parameter value
Note: After each exit of Installer+ mode, the parameter load request is sent to all DSPs in the chain. This takes
approx 15 seconds to complete.
3.14.11
INSTALLER+ MODE
A
B
C
E
D
G
F
B + C for 3 sec.