5-16
3.3 Performance tests for type approval
The test items are briefly described below. However, do not actually execute these tests. (To execute
these tests, “PROTECTION” must be canceled.)
ECC ERROR CALLECC ERROR CALL
ECC ERROR CALLECC ERROR CALL
ECC ERROR CALL
If this item is “ON”, the ECC included in transmitting messages is set to erroneous values.
Be sure to set this item at “OFF”.
REPETITION CALLREPETITION CALL
REPETITION CALLREPETITION CALL
REPETITION CALL
This item sets the number of repetition and period of a call. When [ENT] key is pressed after these
settings has been made, the call starts repeatedly.
DISTRESS SCANDISTRESS SCAN
DISTRESS SCANDISTRESS SCAN
DISTRESS SCAN
This test stops the scanning receive of distress watch keeping frequencies.
IGNORE IDIGNORE ID
IGNORE IDIGNORE ID
IGNORE ID
If this item is set at “ON”, all the calls can be received, regardless of the call addresses specifying
individual, group, and geographic area calls. When this item is set at “OFF”, only the calls addressed to
the own ship are received. Be sure to set this item at “OFF”.
ERRERR
ERRERR
ERR
OR RAOR RA
OR RAOR RA
OR RA
TE MEASURETE MEASURE
TE MEASURETE MEASURE
TE MEASURE
The first receiving call after pressing [ENT] key is set as the reference of character error rate of receiv-
ing calls, and the error rates of the second and later calls are measured in comparison with the reference.
3. Test through the Setup Menu
***** T/A test *****
ECC ERROR CALL
REPETITION CALL
IGNORE ID
ERROR RATE MEASURE
: OFF
: OFF
DIST SCAN : ENABLE
To Next Page
Loading...
