Furuno SC-130 - SAFETY INSTRUCTIONS; Installer Safety Guidelines

ii
SAFETY INSTRUCTIONS
The operator and installer must read the applicable safety instructions before attempting to operate or
install the equipment. Failure to comply with these safety instruction may cause injury, loss of life or
damage to the equipment.
Safety instructions for the installer
Indicates a potentially hazardous situation which, if not avoided,
will result in death or serious injury.
DANGER
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
WARNING
Indicates a potentially hazardous situation which, if not avoided,
can result in minor or moderate injury.
CAUTION
Warning, Caution
Prohibitive Action
Mandatory Action
Observe the following safe compass
distances to prevent interference to a
magnetic compass:
Standard
compass
Steering
compass
0.50 m 0.30 m
Display Unit
SC-702
1.35 m 0.85 m
Junction Box
SC-701
Antenna Unit
SC-703
0.40 m 0.30 m
Antenna Unit
SC-1303
0.30 m 0.30 m
Remote Display Unit
RD-50
0.45 m 0.30 m
Remote Display Unit
RD-20
1.25 m 0.80 m
Ground the equipment to prevent
electrical shock and mutual
interference.
Use the specified power cable.
Fire can result if an incorrect cable is used.
Turn off the power at the mains
switchboard before beginning the
installation.
Fire, electrical shock or serious injury can
result if the power is left on or is applied
while the equipment is being installed.
Do not install the equipment where it
may get wet from rain or water splash.
Water in the equipment can cause fire,
electrical shock or damage to the
equipment.
Do not disassemble or modify the
equipment.
Fire, electrical shock or serious injury
can occur.
WARNING
ELECTRICAL SHOCK HAZARD
Do not open the equipment unless
totally familiar with electrical circuits
and service manual.
Only qualified personnel should work
inside the equipment.
CAUTION