2. OPERATION
2-38
2.17.4 How to save a sensor log
You can save a log file for your GNSS, sensor or offline (both GNSS and sensor) data.
1. Open the [MENU].
2. Select [SYSTEM], then press the ENT key.
3. Select [LOG RECORDING], then press the ENT key. The [LOG RECORDING]
menu appears.
4. Select [LOG TYPE], then press the
ENT key. An options pop up window
appears.
5. Select the appropriate option, then
press the ENT key.
• [OFF]: No log data is saved.
• [GNSS ONLY]: Only GNSS core log data is saved.
• [SENSOR ONLY]: Only sensor log data is saved.
• [OFFLINE DATA]: Both GNSS and sensor log data is saved as offline data.
6. Select [DESTINATION], then press the ENT key. An options pop up window ap-
pears.
7. Select the appropriate option, then press the ENT key.
• [USB]: Log data is saved to the USB Flash Memory.
• [MP]: Log data is saved to the device connected via the Remote Maintenance
port.
8. Close the [MENU].
2.17.5 How to clear display settings and GPS memory
You can reset the display settings and clear the GNSS (GPS) memory.
1. Open the [MENU].
2. Select [SYSTEM], then press the ENT key.
3. Select [RESET SETTING], then press the ENT key. The [RESET SETTINGS]
menu appears.
4. Select the appropriate option, then press
the ENT key. A confirmation window ap-
pears.
Note: The [FACTORY DEFAULT] menu
item is reserved for technical personnel
and is not selectable.
5. Select [YES] to reset the settings, or [NO] to cancel.
2.18 ROTI Display Operations (RD-50/RD-20, option)
The optional RD-50/RD-20 Remote Display Unit is available as a remote display for
ROTI data only. Operations and settings for the RD-50 are outlined in the RD-50 op-
erator’s manual (OME-44530-x; x denotes the manual version), supplied with the RD-
50.
To Next Page
Loading...
